Heat Press Batting Together is 1-1/2in x 10 yard roll cloth tape that will fuse two edges to of batting together. It's soft, its thin, it stretches, its needle easy for hand or machine quilting. This can be used on any batting fabric content.
Works on all batting.
Always follow manufacturers instructions.
Directions for using HEAT Presss Batting Together:
Iron Settings are Most Important when applying tape. Irons with Teflon plates can use low cotton to fuse tape. Irons without a teflon plate use the new instructions below. Test your iron with tape and batting. * 100% polyester batting... low setting.. (high synthetic) and use and up and down motion until the glue is set. You can use a low shot of steam to finish the fusible process holding the iron above the tape.
* Test all synthetic mixed battings ~ usually a wool setting works well.
You may find that the batting looks flat after application but when it cools the batting is fluffy again.
With a large quilt batting 93" and adding more width, I use weights on either side of the batting to hold it in place.
Use and up and down motion with the iron as you place the tape for the first time on the batting edges. When the tape is set in place then apply heat and you may use a little light steam to completely melt the glue backing. You will find that the tape is soft, flexible, stretches and is easy needle ready for either hand quilting or machine quilting. It's FAST AND EASY
You may consider using an Applique Pressing Sheet. Our item number: 3122 or 3122b